from $45 / linear ft

Fence Repair, Painting & Installation

Posts set properly, so the fence is still straight in ten years

See pricing
Paver patio along a new metal-panel privacy fence in Costa Mesa
Privacy fence and paversCosta Mesa

A fence fails from the ground up. Posts set too shallow, set in dirt instead of concrete, or set with the end grain sitting in a puddle – those are the three reasons fences lean, and no amount of good lumber above ground fixes any of them.

We set posts at a minimum of two feet deep in concrete with a gravel base underneath for drainage, and we crown the concrete so water runs away from the post rather than pooling against it. It costs a bit more on install day and it is the difference between a fence that lasts eight years and one that lasts twenty.

We also do a lot of repair work, which is often the smarter spend. If the posts are sound and only pickets or rails have gone, replacing those and re-staining costs a fraction of a new fence and looks the same from the street. We will tell you which situation you are in.

1Pricing

Three ways this gets quoted

New fencing priced per linear foot including posts, concrete, hardware and haul-away of the old fence. Repairs and refinishing are quoted per job.

  1. 1 / 3

    Repair & Restore

    Fix what is failing, keep what is fine.

    • Leaning posts reset or sistered
    • Rotted pickets and rails replaced
    • Gates re-hung, squared and re-hardwared
    • Storm and impact damage repaired
    • Matched to your existing fence profile

    from$650

  2. 2 / 3

    Stain & Paint

    UV protection that holds up to a Valley summer.

    • Pressure wash and full surface prep
    • Loose and failing finish removed
    • Semi-transparent stain or solid exterior paint
    • Both sides and post caps coated
    • Landscaping masked and protected

    from$8.50per linear ft

What drives the price: read the LA cost guide

2How it runs

Our fencing process

  1. Step 1 / 4

    Walk the line

    We walk the fence line with you, confirm where the property line actually sits, check the city's height limits for your setback, and note anything – slope, tree roots, utilities – that changes how it has to be built.

  2. Step 2 / 4

    Demo and dig

    Old fence out and hauled away. Utilities located before any digging. Post holes dug to depth with a gravel base for drainage.

  3. Step 3 / 4

    Set and build

    Posts set plumb in concrete and left to cure, then rails and pickets go on with the correct fasteners. Gates get diagonal bracing so they do not sag in year two.

  4. Step 4 / 4

    Finish

    Stain or paint applied to both sides if that is part of the scope, hardware adjusted, site raked clean and all offcuts removed.

“Two hundred and twenty feet of cedar, posts set two and a half feet deep in concrete. Three winters later it is still dead straight. The fence it replaced had lasted six years.”
Robert C. – Woodland Hills

3FAQ

Fencing questions

The things people ask before they book. If yours is not here, call and ask it.

(213) 375-0868
  • Wood fencing runs $45–$75 per linear foot installed depending on height and material, so a typical 100-foot back yard lands between $4,500 and $7,500. Vinyl sits at the upper end of that range but needs no refinishing. Repairs to an existing fence usually come in between $650 and $1,800.

5Free estimate

Get a fixed price for fencing

New fencing priced per linear foot including posts, concrete, hardware and haul-away of the old fence. Repairs and refinishing are quoted per job. Free walkthrough, written quote, no follow-up sales calls.

(213) 375-0868
  • Calls answered 24/7
  • CA License #1156332 – licensed, bonded and insured
Book online (opens in a new tab)
Call us